Digimatic pneumoelectric measuring instrument uses US precision differential pressure sensor. Sizes of workpieces can be calculated through the measured air pressure change value. Nominal value or tolerance value is displayed on the screen. With key panel, various parameters can be set in accordance with the requirements; measured values are stored in a built-in large capacity SD storage card; external RS485 and RS232 interfaces, convenient for data uploading; external USB2.0 interface, exporting the saved data to the USB disk; external input and output I / O are used for external device control.
|
Voltage |
AC176 ～ 264V 50Hz/60Hz |
|
Consumption |
15W |
|
Air supply |
0.4MPa Compressed air |
|
Working temperature |
-20~60℃ |
|
Digimatic resolution |
0.1um |
|
Light column resolution |
0.1um |
|
Tolerance range |
100um |
|
Repeatability |
0.1um |
|
Channel amount |
One (Dual channel is optional) |
|
External size |
170*66*366mm |
|
Built-in memory card capacity |
8GB |
|
Data output interface |
DB9 interface RS232 |
|
Input and output interface |
DB25 |
The maximum resolution is up to 0.1μm, and boot without preheating
Simultaneous display of nominal value and tolerances of measured sizes
Highlight LCD display
Automatic conversion instructions of three-color light columns
Chinese menu. Intuitive display of various contents, and easy to operate
A large amount of measurement data can be stored, so that data are not lost when the power is off
Ten sets of programs can be set up, for a variety of specifications measurements
Large range of magnification can extend the life of the probe by more than 50%.
Input and output: Optical coupling isolated IO input and output interface
RS232 or RS485 communication function
